i was reading a post a while back about having to put a check valve inline with the amp sensor when running a turbo. does anyone have any specific information about how to do it correctly or where to buy one? i am building a custom turbo header this winter and bending all the charge pipes but am a little unsure about the check valve, also is there any other major things to do before bolting it all on other than oil lines and coolant ? all help is greatly appreciated.
We sell a 2 bar Map Sensor upgrade for $135. We also make a Map Sensor Reuse boost controller. The ecotec engine does not come with a typical map sensor. The map sensor is directly connected to the top of the manifold. We have designed a system that will replace it. contact us if you are intrested.
i haven't thrown any codes yet....might not need the check valve. <br>
Cost of mods: $2500
Number of headaches during install: Too many to count
Look on your face when you realized you got beat by a Cavalier: PRICELESS